M2M EASY 2 FIRE COMMUNICATOR

Reliable wireless fire alarm and remote monitoring for safety monitoring centers.

With its use, the alarms of the connected, external fire alarm system can be transmitted, and the device receives and transmits the errors detected by the fire alarm system on the inputs.

Its two inputs are also suitable for fire alarm supervision, break detection, and sabotage.

In case of a status change, the device generates an immediate alarm, which is sent – in standard Contact ID format (with CID code) – via the LTE or GSM/GPRS mobile network to the IP address of the remote monitoring center. The device also provides and reports vital signs according to the set frequencies.

The alarms are reported within the required 10 seconds.

By using our device, you can increase the efficiency of your current fire alarm system!

You can request immediate SMS notification of alarms (to up to 4 phone numbers).

You can also use the device to connect a siren on its output. The pre-configured product is easy to use and the device is accessible remotely.

Compatible with fire control panels and fire alarm systems.

Operating modes

Analog voice call-based alarm reporting to fire protection center (on GSM line)
Wireless transmission (to IP receiver, remote monitoring IP address)
Monitoring of connected fire alarm system

Application areas

Remote monitoring and fire alarm centers
Fire protection and fire alarm systems
Monitoring of fire alarm systems

Design

Aluminum housing (easy to mount on wall / security box, fire protection standard color)

Communication

LTE / GPRS cellular network
GSM voice call (for traditional dispatch centers)

Connectors

2 isolated digital inputs (for fire protection system fault detection)
- voltage (high level: 5-24V, low level: 0-1V)
- contact (0.3-1mA)
- cable break, short circuit and sabotage detection
Relay output (remote switching: 2A-120VAC, 1A-24VDC)
Simulated analog line (ALARM TIP-RING) input for fire alarm/fire protection systems
Power/battery connector (8-24VDC, 800mA – terminal block)
Configuration port (RJ11 or USB port, fror firmware updates)
SMA-M antenna connector (50 Ohm)
Push insert-SIM card slot

Software features

Receiving fire protection system signals and generating CID for events, providing vital signs
Fire reporting to dispatch center via cellular network (analog GSM voice call to max. 4 phone numbers)
Fire reporting to IP address via cellular network (primary, backup server)
Zones, event management
Voltage/contact input line status reporting (in case of state change)
Output delayed switching (locally, via SMS commands, call/ringing, TCP)
Call number list for output control
Alarm SMS notifications, reports
Voice call/ringing in case of alarm (up to 4 phone numbers)
Compatibility with M2M Fire protocol (SIA CID/DTMF), Enigma protocol (Enigma II receiver, IP2 Receiver)

Configuration

EasyTerm parameter configuration software (for Windows systems)
- Configuration (serial port, with SMS commands, TCP/IP)
- Firmware update/config. settings download/upload (serial port, FTP)
- Remote access (TCP)
LED display according to current fire safety regulations

Security

Watchdog (monitoring and automatic recovery)
Settings storage in memory
Siren / bark output
Cable break, short circuit and tamper detection

Optional Accessories

RS232-RJ11 cable (for performing settings and software updates)
USB cable (for performing settings and software updates)
Various types of SMA antennas